dcdc specification 2 watts ? low cost ? dip24 package ? operating temperature 40 c to +100 c ? single & dual outputs ? optional metal case ? optional isolation to 6000 vdc ? 3 year warranty jah series input input voltage range ? nominal 10% input current ? see table input filter ? pi network input reverse voltage ? none protection undervoltage lockout ? none input reflected ripple ? 35 ma pk-pk through 12 h inductor, 5 hz to 20 mhz input surge ? 5 v models 7 vdc for 100 ms 12 v models 15 vdc for 100 ms 24 v models 28 vdc for 100 ms output output voltage ? see table minimum load ? no minimum load required initial set accuracy ? 2% max start up delay ? 20 ms typical start up rise time ? 20 ms typical line regulation ? 0.5% max load regulation ? 0.5% max single & dual models (1.0% max for 3v3 versions) (see note 6) cross regulation ? 5% on dual output models (see note 4) transient response ? 3% max deviation (5% for 3v3 output), recovery to within 1% in 2 ms for a 50% load change ripple & noise ? 75 mv pk-pk measured with 20 mhz bandwidth short circuit protection ? output shuts down with auto recovery maximum capacitive ? see tables load temperature ? 0.02/c max coefficient xppower.com general efficiency ? see tables isolation ? 1000 vdc input to output, for optional high isolation versions up to 6000 vdc input to output (see note 1) 1000 vdc input to case 1000 vdc output to case isolation resistance ? 10 9 ? switching frequency ? 40 khz typical singles, 300 khz typical duals power density ? 5.21 w/in 3 mtbf ? >3 mhrs to mil-hdbk-217f at 25 c, gb environmental operating temperature ? -40 c to +100 c, derate from 100% load at +85 c to no load at +100 c case temperature ? +100 c max storage temperature ? -40 c to +125 c humidity ? up to 90%, non-condensing cooling ? natural convection emc & safety emissions ? en55022 class a, conducted & radiated with external components (see application notes) esd immunity ? en61000-4-2, level 3, perf criteria a eft/burst ? en61000-4-4, level 3, perf criteria a (see note 5) surge ? en61000-4-5, installation class 2, perf criteria a (see note 5) conducted immunity ? en61000-4-6, 10 vrms, perf criteria a magnetic fields ? en61000-4-8, 1 a/m, perf criteria a
15-sept-11 dcdc jah02 mechanical details application notes models and ratings notes notes input filter 1. all dimensions are in inches (mm) 2. weight: plastic case: 0.028 lbs (12.5 g), metal case: 0.033 lbs (15.0 g) 3. pin diameter: 0.020.002 (0.50.05) 4. pin pitch tolerance: 0.014 (0.35) 5. case tolerance: 0.02 (0.5) n.p : no pin n.c : no connection bottom view 0.90 (22.86) 0.60 (15.24) 0.20 (5.08) 0.01 (0.25) 0.02 (0.50) 31 22 15 13 24 2 10 1211 23 14 input voltage output voltage output current input current (2) maximum capacitive load efficiency model number (1,3) no load full load 5 v 3.3 v 500 ma 75 ma 622 ma 330 f 53% jah0205s3v3 5.0 v 400 ma 75 ma 615 ma 330 f 65% jah0205s05 9.0 v 222 ma 75 ma 597 ma 330 f 67% jah0205s09 12.0 v 166 ma 75 ma 571 ma 330 f 70% jah0205s12 15.0 v 133 ma 75 ma 588 ma 330 f 68% jah0205s15 24.0 v 83 ma 75 ma 615 ma 330 f 65% jah0205s24 3.3 v 300 ma 30 ma 638 ma 1000 f 62% jah0205d03 5.0 v 200 ma 30 ma 588 ma 1000 f 68% jah0205d05 9.0 v 111 ma 40 ma 571 ma 470 f 70% jah0205d09 12.0 v 83 ma 40 ma 571 ma 470 f 70% jah0205d12 15.0 v 67 ma 40 ma 571 ma 470 f 70% jah0205d15 24.0 v 42 ma 50 ma 579 ma 220 f 69% jah0205d24 12 v 3.3 v 500 ma 70 ma 245 ma 330 f 56% jah0212s3v3 5.0 v 400 ma 70 ma 260 ma 330 f 64% jah0212s05 9.0 v 222 ma 70 ma 245 ma 330 f 68% jah0212s09 12.0 v 166 ma 70 ma 238 ma 330 f 70% jah0212s12 15.0 v 133 ma 70 ma 252 ma 330 f 66% jah0212s15 24.0 v 83 ma 70 ma 256 ma 330 f 65% jah0212s24 3.3 v 300 ma 20 ma 250 ma 1000 f 66% jah0212d03 5.0 v 200 ma 20 ma 228 ma 1000 f 73% jah0212d05 9.0 v 111 ma 20 ma 222 ma 470 f 75% jah0212d09 12.0 v 83 ma 20 ma 213 ma 470 f 78% jah0212d12 15.0 v 67 ma 35 ma 216 ma 470 f 77% jah0212d15 24.0 v 42 ma 35 ma 219 ma 220 f 76% jah0212d24 24 v 3.3 v 500 ma 25 ma 120 ma 330 f 57% jah0224s3v3 5.0 v 400 ma 25 ma 132 ma 330 f 63% jah0224s05 9.0 v 222 ma 25 ma 132 ma 330 f 63% jah0224s09 12.0 v 166 ma 25 ma 122 ma 330 f 68% jah0224s12 15.0 v 133 ma 25 ma 122 ma 330 f 68% jah0224s15 24.0 v 83 ma 25 ma 122 ma 330 f 68% JAH0224S24 3.3 v 300 ma 15 ma 121 ma 1000 f 68% jah0224d03 5.0 v 200 ma 15 ma 114 ma 1000 f 73% jah0224d05 9.0 v 111 ma 15 ma 111 ma 470 f 75% jah0224d09 12.0 v 83 ma 15 ma 104 ma 470 f 80% jah0224d12 15.0 v 67 ma 20 ma 108 ma 470 f 77% jah0224d15 24.0 v 42 ma 20 ma 111 ma 220 f 75% jah0224d24 1. for optional 3000 vdc isolation add suffix -h to model number. for optional 4000 vdc isolation add suffix -h4 to model number. for optional 5000 vdc isolation add suffix -h5 to model number. for optional 6000 vdc isolation add suffix -h6 to model number. 2. input current measured at nominal input voltage. 3. for optional metal case add suffix -m. metal case is only an option up to 3000 vdc isolation versions eg. jah0212s15-hm. 4. cross regulation is 5% when one output is at 100% and the other is varied between 25% and 100%. 5. a 220 f/250 v capacitor across the input is required in order to meet en61000-4-4 and en61000-4-5. 6. dual output regulation is specified with a balanced load. 0.40 (10.16) 0.12 (3.05) min. 1.25 (31.75) 0.80 (20.32) pin connections pin single dual single -h dual -h 1 +vin +vin +vin +vin 2 n.c. -vout +vin +vin 3 n.c. common n.p n.p 10 -vout common n.p common 11 +vout +vout n.p common 12 -vin -vin -vout n.p 13 -vin -vin +vout -vout 14 +vout +vout n.p n.p 15 -vout common n.p +vout 22 n.c. common n.p n.p 23 n.c. -vout -vin -vin 24 +vin +vin -vin -vin single output models dual output models c1 l1 c1 l1 220 f/100 v 12 h 220 f/100 v 22 h +vout +vin -vin load -vout c1 l1 + - dc/ dc converter
|
